Ruckus Wireless ZoneFlex 2741 802.11g Guide de l'utilisateur télécharger pdf (Page 39)

Deploying the Access Point

Step 1: Complete the Power Connections

Use DC Power

To use DC to power the Access Point, you need to connect a DC cable (not supplied with

the Access Point) to the DC terminal block.

1. Take out the DC terminal block from the small plastic bag that contains the bottom

cover of the Access Point.

2. Connect the DC cable’s ground wire to V- terminal. If you are looking at the terminal

block with the wiring terminal screws on top, the V- terminal is on the left side.

3. Connect the DC cable’s +12v DC wire to the V+ terminal. If you are looking at the

terminal block with the wiring terminal screws on top, the V+ terminal is on the right

side.

Figure 22. Connect the ground wire to the V- terminal and the +12v DC wire to the V+

terminal

4. Using a 3mm Phillips screw, tighten the wiring terminal screws. Screw torque value must

be 4kg-5kg.

5. Connect the DC terminal block to the 12V DC port on the Access Point.

WARNING: Do not apply power to the Access Point at this point. You should connect the

Access Point to a power source only after you finish connecting all other components in

“Step 3: Connect the Access Point to the Network” on page 38.

Ground Wire to

V- Terminal

12V DC Wire to

V+ Terminal

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 57 58

Pas de commentaire

Ruckus Wireless ZoneFlex 2741 802.11g Guide de l'utilisateur Page 39