Ruckus Wireless ZoneFlex series Guide de l'utilisateur télécharger pdf (Page 105)

Managing the Access Point

Running Diagnostics

2. Click Reset Now (next to Restore to factory settings?).

After a brief pause, you will be automatically logged out of the AP. You must now

disconnect the AP from the switch (and the network) and reconnect it to your

computer, as described in “

Step 1: Preconfigure the Access Point” on page 31. At this

time, you can restore the network settings, then replace it in your site for full network

use.

Running Diagnostics

Two network connection diagnostic tools – PING and traceroute – have been built

into the AP to help you check network connections from the Web interface.

To run diagnostics for network troubleshooting

1. Go to Administrator > Diagnostics. The Administrator :: Diagnostics page

appears. Two options are available:

• Ping

•Traceroute

2. Click the text field by the option you want to activate, and type the network

address of a site you wish to connect to.

3. Click Run Test.

The results appear in the text field below each option.

Figure 50. Pinging ruckuswireless.com

1 2 ... 100 101 102 103 104 105 106 107 108

Pas de commentaire

Ruckus Wireless ZoneFlex series Guide de l'utilisateur Page 105