Ruckus Wireless ZoneFlex series Guide de l'utilisateur télécharger pdf (Page 52)

Installing the Access Point

Step 2: Verify Access Point Operation

Check the LEDs

Perform a spot-check using the LEDs to verify that the Access Point is operating

normally. Refer to the following sections for information on how to check the LEDs on

each ZoneFlex AP model.

ZoneFlex 2741/2942/7343/7942

If the Access Point is operating normally and your wireless client was able to associate

with it:

■ The WLAN LED is green.

■ If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is

off. This indicates that the Access Point is operating in standalone mode. If there

is a ZoneDirector device on the network, the DIR LED is green.

ZoneFlex 7363 and 7962

If the Access Point is operating normally and your wireless client was able to associate

with it:

■ The 2.4G or 5G LED is green.

■ If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is

off. This indicates that the Access Point is operating in standalone mode. If there

is a ZoneDirector device on the network, the DIR LED is green.

ZoneFlex 7762

If the Access Point is operating normally and no wireless clients are associated with it:

■ The Power LED is green.

■ The Status LED shows slow blinking amber. This indicates that there are no

wireless clients connected to the Access Point’s WLAN service.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 107 108

Pas de commentaire

Ruckus Wireless ZoneFlex series Guide de l'utilisateur Page 52