Ruckus Wireless ZoneFlex series Guide de l'utilisateur télécharger pdf (Page 64)

Configuring the Access Point

Configuring the Network Settings

NOTE: If the built-in heater is disabled, the lowest operating temperature that the

Access Point can support is -20° C.

Configuring the Network Settings

This section describes how to view and configure the AP’s network settings. Topics

discussed include:

■ Default IP Addressing Behavior

■ Obtaining and Assigning an IP Address

■ Configuring the L2TP Settings

Default IP Addressing Behavior

By default, the AP is configured to automatically obtain an IP address from a DHCP

server on the network. If the AP does not detect a DHCP server, it automatically assigns

itself the static IP address 192.168.0.1 to make it easier for you to preconfigure

and deploy it on your network.

Obtaining and Assigning an IP Address

There are at least two instances when you would change the IP address of the AP:

■ If the current AP IP address consistently conflicts with that of any other device in

your network

■ If you want to switch to a static IP address from DHCP, for use in managing or

maintaining the AP

Unless you are able to determine the IP address assigned by the DHCP server to the

AP, it may prove helpful for anyone needing administrative access to assign a static

IP address to the AP.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 107 108

Pas de commentaire

Ruckus Wireless ZoneFlex series Guide de l'utilisateur Page 64